Expert Answers about Grand Design Imagine Travel Trailer
- Troubleshooting the Replacement Cup Holder for Thomas Payne
- To operate the lights on the Cup Holder for Thomas Payne Momentum Recliners and Sofas # 195-387597 you just use the button found on the outer ring of the cup holder (be sure that it is not locked). If when the lights are off, the system is still lit (other than the small spots on the buttons) you likely have a malfunction and will want to unplug the chair to reset it. If that doesn't solve the issue, then the switch is bad and you will need the Replacement Cup Holder for Thomas Payne Momentum...
view full answer... - Furrion Observation System Monitor Goes Blank With WiFi Signal Turned On
- The reason you are having an issue with the Furrion RV Observation Camera System part # FOS43TASF while connected to WiFi in your Chevrolet Silverado is because they both operate off of radio waves that use the same frequency. Therefore, whenever you turn your truck on and the WiFi signal activates the monitor will lose signal because it picks up the radio frequency from the WiFi instead of the radio frequency from the camera.
In order to use the Furrion RV Observation Camera System with...
view full answer... - Troubleshooting Tail Light Issues on New Grand Design Trailer
- Since you tested the tow vehicle's connector and know it's working properly, we can at least focus all our attention on the trailer side. It sounds like you've already done this, but it certainly sounds like there's some kind of ground issue on the Grand Design that's causing the dim lights, and now the issue on the left side tail light.
Check once more to make sure all your ground connections, both the main harness ground for the 7-Way and each individual ground for the light assemblies...
view full answer... - Troubleshooting Lippert Power Tongue Jack LED Lights Staying On With Switch Turned Off
- Since this is a brand new jack you shouldn't be experiencing problems. I spoke with my contact at Lippert who said he hasn't heard of this being a very common issue and your best bet is a bad ground or a new switch. It is also possible that you could get the unit swapped out for a new jack if it is still under warranty. I recommend checking into that first.
If the LED lights on your Lippert # LC285318 Electric Trailer Jack are still illuminating when the switch is off then you either have...
view full answer... - Do Old Furrion Vision S Cameras have to Be Unpaired to Pair to New Cameras
- The good news is you don't have to unpair from cameras that don't have access to any longer and would only need to pair the monitor to new cameras.
On the menu of the Furrion Vision S system scroll to pairing and then select rear camera. It should find the camera but if not go back to the camera and find the pairing button on it and hold it down.
view full answer... - Troubleshooting A Furrion Vision S RV Camera System Monitor That Goes Black When Using View All
- I spoke with Furrion and found that this is a known issue with the wiring on the side marker cameras # FCE48TASL. A lot of people have been installing the trigger wire in with the power wire instead of running it to the turn signal or just capping it off. I've attached an installation video I did below where I show the wires for the cameras at the 6:18 minute mark.
You'll want to remove the whole side marker camera from the trailer to get to the wiring and disconnect the trigger wire...
view full answer...
Go To Results